 |
| XLAB DAY LIGHT TRAINING STROBE |
|
| • Features • Instructions • Retail Price |
Don’t be seen
without it...without
it you won’t be seen
Inspired by dozens of triathletes who
have been injured while training, Xlab’s
chief guru set a goal to introduce a
Daylight Training Strobe with 5 bright
LEDs, a 270 degree visibility, weighing
under 35 grams. Another Xlab World’s
first. ‘Don’t be seen without it.’
| |
|
| Features |
5 Super BRIGHTLEDs
Up to 270° Visibility
Modes BLINKING, CONSTANT, SWEEP, RANDOM
Mounts on ALL XLAB WINGS and round seat posts
ONLY 31 Grams excl. Batteries
Water Resistan
AAA Batteries included
Seen up to 2000 FEET (600m)
Runtime from 250 HRS (Random) to 70 HRS 9Steady)
|
| |
|
|
|
Shown on CARBON SONIC
Shown on CARBON SONIC
Shown on SUPER WING
Shown on FLAT WING
Shown on MINI WING
Shown on SONIC WING
Shown on CARBON WING
Shown on CARBON WING
fit on all other xlab wings
train safer!
| |
|
| Instructions |
BATTERY INSTALLATION
- Remove the top cap with a coin
- Install 2 AAA Batteries into main unit, snap the case down
IMPORTANT
- Replace with only the specified type of batteries
- DO NOT use old battery with new one
- Be careful to check polarity
|
| |
IMPORTANT
- Tighten hardware to 30 in.lbs torque.
- Slide Strobe on to Light Clip.
- Ride safely with bright jerseys.
INSTALLATION ON ROUND SEATPOST
- Place the Circle Bracket around the seat post.
- Place the screw through the Light Clip and in to the Circle Bracket and tighten.
- Slide light on to Light Clip
INSTALLATION ON XLAB SUPER AND CARBON WINGS
- Pass the short screw through a plain
washer, hole ’B’ in the Bracket, the
lower hole in the back of your Wing,
and then add a plain washer and
locknut. Tighten so the bracket is
orientated as shown in the diagram.
- Pass the long screw through a plain
washer, Light Clip, star shaped
washer, hole ‘A’ in bracket, plain
washer and locknut. Position Light Clip
so it is pointing straight back and is
horizontal.
INSTALLATION ON ALLOTHER XLAB WINGS
- Pass the long screw through a plain
washer, Light Clip, star shaped
washer, hole in Mounting Plate, plain
washer and locknut. Position Light Clip
and Mounting Plate so they are in line.
- For the Sonic and Carbon Sonic
attach front of Mounting Plate to
lower back hole with the small screw,
plain washer and locknut. An
alternative is to place front end of
the Mounting Plate between the
hexagonal silver stabilizer and the
right hand Sonic side plate.
- For the Flat Wing place the front
of the Mounting Plate between the
outside of the Flat Wing and the
top mounting hole of the right cage.
Reinsert hardware and tighten.
- For the Mini Wing place the front
of the Mounting Plate between the
bottom plate and the lower hole of the
right cage. Reinsert hardware
and tighten.
|
|
|
 |
